Book a call
  1. Home
  2. Solutions
  3. District heating

Solutions / District heating

Monitoring of pre-insulated pipelines and substations for district heating

Leak detection on pre-insulated pipes, on-site section testing and substation monitoring.

01 / Challenge

What you typically face

  • Failures on pre-insulated pipes are found only when the damage is big
  • Excavating without the exact fault location is expensive
  • Substations are spread out and checked manually

02 / Solution

How we solve it

01

Permanent section monitoring

MSD8970E continuously monitors the alarm wires and reports leaks, breaks and short circuits - up to 6,000 m per channel, with a relay output for SCADA.

02

On-site testing

We test sections, locate the failure and deliver a report with a chart, so excavation is targeted.

03

Substation monitoring

IMS modules measure temperatures, pressures and states and send alarms over 4G to the IntelityNET platform.

FAQ: district heating

What does the MSD8970E connect to?

To the alarm wires of pre-insulated pipelines (supply, return, DHW). The relay output (NO/NC) connects to the PLC and SCADA system.

How long a wire can be monitored per channel?

Up to 6,000 m of alarm wire per channel, with signal loops of up to 2,000 m recommended for more precise detection.

Contact / inquiry

Book a technical call

Describe your task in a few sentences. You will hear back from an engineer who works on projects like yours, with a first feasibility assessment and the questions we need for a quote. If we are not the right fit, we will tell you straight away.